Typical component families we produce for equipment builders. Every part is machined, deburred and inspected under one roof.
Turned and ground shafts with tight concentricity.
View →Machined housings and enclosures with sealing faces.
View →Structural and motion components for robotics.
View →Mounts, spacers and housings for optical assemblies.
View →Wafer-handling and chamber parts with low particle generation.
View →Bushings, sleeves and bearing seats held to tight fits.
View →Brackets and mounts with accurate hole position.
View →Fluid blocks with clean passages and sealing faces.
View →Fixtures and tooling with repeatable clamping.
View →Base, cover and separator plates, flat and parallel.
View →Small complex parts from Ø 2 mm.
View →Tell us about your program. The fields below help our engineering team prioritize recurring, long-term supply programs with equipment manufacturers.
Every critical dimension is verified on our in-house Zeiss CMM · material chemistry confirmed by spectrometer · EN 10204 3.1 certificates available.
Prefer email? Write to us directly at info@prototech-machining.com