Held tolerances, on the part
Surface finish and geometry achieved on real production parts — measured and verified, not estimated.
From multi-axis milling to tight-tolerance turned parts — the processes we use to hold your drawings, batch after batch.
Every process below is backed by ISO 9001:2015 control, CMM verification and lot traceability. Pick the one that matches your geometry and volume.
3-, 4- and 5-axis milling and turning for equipment-grade metal and plastic parts.
Complex geometries cut complete in one setup — fewer fixtures, tighter positional stacks.
Precision turned shafts, sleeves, rings and threaded features from bar and near-net stock.
Swiss-type lathe work for small, slender, high-volume components.
PEEK, PVDF, PTFE and other polymers machined without stress cracking.
Sub-10 µm features, critical bores and datums held across the batch.
Not sure which process fits? Ask in your quote request.
Surface finish and geometry achieved on real production parts — measured and verified, not estimated.